RFID Configure

 12 July 2012

Assamualaikum ....

Begin the new task that is RFID Proximity Access Control System. The system is simpler compared to another security system. The RFID eco entry door access system allows the user to open the door using a keyfob, password, or keyfob plus password.

The configuration jumper

J1 -      This is used to select whether the lock is supplied power to keep

it closed (NC), or is only supplied power to open the lock (NO)

Select (NO) for all 4tronix locks and releases

J2 -      This is used to select a high voltage (12V) or low voltage (2V) for

lock operation. This is supplied set to 12V and should be left like

this for all 4tronix locks

S16 -    This is only used to reset the master password. See following

instructions. Leave connected between Pin1 and Pin2.

            The manual instruction monitors us to install the password and keyfob into RFID system.

There have four important  step  such as entering and exiting system configuration mode, changing the master password, add new user (keyfob), add new user ( password entry ).

           
The another four setting step to backup set up if user lose their password , wrong key in keypad and etc. The setting is remove one user, remove all users, set door open, reset master password.

The manual instruction is show below:-

Firstly configuration,

System configuration mode:

1.      Normal  operation mode

2.      Press # key

3.      Then press the 5-key master password (default 12345)

4.      Now in system configuration  mode

5.      In this mode you can perform all the configuration you need, without exiting the mode