RFID Controller

19 July 2012

Assamualaikum ....

 This a image of RFID door lock. My group must configure the card and password for door work to locking.

Configure the RFID with password and keyfob

13 July 2012

The ecoEntry door access system allows the user to open the door using a keyfob, password, or keyfob plus password.

New Task

17 July 2012 

Assalamualaikum ....

As usually every of the team member HIIS work with their task until finish.
The trainee come on early morning at 9 am to work in the group with their task.


Me and two other member works on the configuration on the RFID door lock on the early
morning. The instruction manual was required with the RFID tools.

Internet are the additional reference to configuration the RFID door lock.

Simple Lab Coding

11 July 2012

Assalamualaikum....

the work begin the new way to know the another type of basic coding such as look En Mazran blog.
Before this , me have a learn a little bit about Pic 16f877 on the lab session. Then, me look
the lab report such as , lab 3 :

#include <16f877a.h>                        // declare file PIC16F877A

#use delay(clock=4000000)              // declare frequency internal oscillator, f=4MHz

#fuses hs,nowdt,nolvp,noprotect     // declaration fuses for PIC function

#byte porta=5                                      // declare address for port a=5

#byte portb=6                                      // declare address for port b=6

#byte portc=7                                      // declare address for port c=7

#byte portd=8                                      // declare address for port d=8

RFID Configure

 12 July 2012

Assamualaikum ....

Begin the new task that is RFID Proximity Access Control System. The system is simpler compared to another security system. The RFID eco entry door access system allows the user to open the door using a keyfob, password, or keyfob plus password.

The configuration jumper

J1 -      This is used to select whether the lock is supplied power to keep

it closed (NC), or is only supplied power to open the lock (NO)

Select (NO) for all 4tronix locks and releases

J2 -      This is used to select a high voltage (12V) or low voltage (2V) for

lock operation. This is supplied set to 12V and should be left like

this for all 4tronix locks

S16 -    This is only used to reset the master password. See following

instructions. Leave connected between Pin1 and Pin2.

            The manual instruction monitors us to install the password and keyfob into RFID system.

There have four important  step  such as entering and exiting system configuration mode, changing the master password, add new user (keyfob), add new user ( password entry ).

           
The another four setting step to backup set up if user lose their password , wrong key in keypad and etc. The setting is remove one user, remove all users, set door open, reset master password.

The manual instruction is show below:-

Firstly configuration,

System configuration mode:

1.      Normal  operation mode

2.      Press # key

3.      Then press the 5-key master password (default 12345)

4.      Now in system configuration  mode

5.      In this mode you can perform all the configuration you need, without exiting the mode